WP series reducer, the worm is made of 45 # high-quality steel after heat treatment, the worm gear is cast with tin bronze, good wear resistance, especially in bearing capacity is more obvious, mainly suitable for plastics, metallurgy, beverages, mine , Hoist transportation, chemical construction and other mechanical equipment deceleration transmission.
electronic content PDF catalog
1. Stable transmission, low vibration, low impact, low noise, large reduction ratio, strong versatility, suitable for all kinds of mechanical equipment.
2. Single-stage transmission, large transmission ratio, compact structure. Most speed reducers have good self-locking performance, and the braking device can save the mechanical equipment with braking requirements.
3. The friction loss between the worm gear and the tooth surface of the worm gear is large, the transmission efficiency is lower than the gear, it is easy to be heated, and the temperature is higher.
4. Higher requirements for lubrication and cooling.
5. Very good match. Worms and worms are manufactured according to national standards.
B. Working conditions:
1. The speed of the worm reducer should not exceed 1500r / min.
2. The working environment temperature is -40 ° C to + 40 ° C. When the working environment temperature is below 0 ° C, the lubricating oil must be heated to above 0 ° C before starting heating. When the working environment temperature is above 40 ° C, cooling Measures must be taken.
3. The feed shaft of the worm gear reducer can rotate forward or reverse.
1. Worm gear shaft shall not be used as input shaft.
2. The machine does not pump oil when it leaves the factory. Before operation, sufficient mechanical oil must be added.
3. The supporting motor (ie power) shall not exceed the value specified in the sign.
4. If the user wants to change the direction of entering the shaft, please remove the lower end cover of the shaft, take out the worm and adjust 180. Load it. According to the installation without knocking hard, you can slowly drive the two shafts to make it mesh.
|Types of:||WP gearbox|
|Speed ratio:||1: 10,15,20,25,30,40,50,60,200,300,400,500,600,800,900,1200,1 500,1800,2400,2500,3000,3600|
|colour:||Blue / silver or according to customer requirements|
Housing: cast iron casting
Worm gear-copper-10-3 #
Carburized and quenched Worm-20CrMn Ti, the surface harness strength is 56-62HRC
Shaft chrome steel 45 #
|filler:||Carton and wooden box|
|Bearing:||C & U Bearing|
|input power.||0.06KW, 0. 09KW, 1.1KW, 1 5KW 2.2KW, 3KW, 4KW, 5 5KW, 7 5KW|
|use:||Industrial machinery: food, ceramics, chemical packaging, dyeing, carpentry, glass.|
|IEC flange:||56B14, 63B14, 63B5, 63B5, 71B14, 80B14, etc.|